SecurityMan PIR-SD Manuale Utente Scaricare il pdf (Pagina 16)

Adding and Cancelling Remote Control

Adding Remote Control:

1) While plugged into the power outlet, press and release the

“Study” button located on the back of the PIR-SD. The PIR-SD will

beep once after being pressed indicating that it is in study mode.

2) Press any one of the four buttons on the remote control 2

consecutive times and the PIR-SD will beep 5 times to indicate

the remote control has been successfully added to the PIR-SD.

Note: The PIR-SD will beep twice to indicate failure during the adding

process and exit the study mode if the signal is not received from the

remote control within 20 seconds. Please repeat steps 1-2 above if this

should happen.

Cancelling Remote Control:

Press and hold down the “Study” button for 5 seconds and then

release, the PIR-SD will beep for 3 seconds to indicate the remote

control is sucessfully cancelled from the PIR-SD.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Nessun commento

SecurityMan PIR-SD Manuale Utente Pagina 16